OzIncidents

Traffic update on Maryvale Road Maryvale level crossing

Maryvale Road Maryvale level crossing, Australia · SCHEDULED ROADWORK

Information

Road conditions and travel information

Live Traffic NSW has published a traffic update for Maryvale Road Maryvale level crossing, New South Wales.

Road conditions

UGL Regional Linx, on behalf of Transport for NSW, is upgrading the level crossing at Maryvale Road, Maryvale. The level crossing will be closed from 6am Monday 10 August to 6pm Friday 4 September (see detours below). Single lane closures and a reduced speed limit will be in place from 30 August until 27 November.

The source identifies this as a planned traffic event.

At the time of this record, the publisher marked the event as not affecting the traffic network.

The source lists a speed limit of 60 km/h.

Published travel advice

Use diversions

Allow extra travel time

Reduced speed limit

To access the Mitchell Highway northbound from Maryvale Road: Seatonville Road, Combo Road, Grangeview Lane and Gravel Pit Lane. Allow approximately 14 minutes travel time.

Published schedule

The published schedule lists road access as “Affected” in both directions during Every Day all day.

The source lists a scheduled start of 10 August 2026 at 6:00 am (Sydney).

The source lists a scheduled end of 27 November 2026 at 6:00 pm (Sydney).

Publication details

The agency last updated this record on 28 August 2026 at 2:04 pm (Sydney).

Location and record context

OzIncidents first recorded this entry on 29 October 2026 at 9:35 am (Sydney). This is a collection timestamp, not a reported incident start time.

Other reports in the surrounding area

These reports are shown for geographic context. They are not confirmed to be the same event, and distances do not describe an impact or evacuation area.

Visit the official agency page ↗

Incident location & geometry

Interactive map loads when JavaScript is available.

Publisher-supplied points and areas may be approximate. They do not show a calculated evacuation zone or the current spread of a fire.

Warning level history

Consecutive repeats are combined. Times show when a level was first observed in the available records, not when the agency issued it.

First observed 29 Oct. 2026, 9:35 am (Sydney)

Information